| Added new report option for Door-Frame Quote Request |
| For Bulk Estimates, there is insufficient information to automatically assign a standard discount when pricing bulk preps. This must be user entered and if a discount has not been entered, a warning message will be displayed advising the user of this condition |
| When changing a double opening to a single opening, any second leaf properties are now removed |
| User defined label, rating and anchors may now be entered directly in the Takeoff and Complete windows for manufacturer’s which are user maintained |
| The Today Window, Tasks list window now shows all columns from project setup task with a filter and print option |
| The Complete Window Costing option now has extended list and extended net columns |
| Hardware preps for paired openings can now be identified specifically to a jamb piece |
| Anchor Preps can now be selected in the Prep Selection window and may be identified to a specific jamb |
| When user maintained manufacturer’s attributes are modified, all existing products descriptions are now modified to reflect the revised definitions |
| The Hardware window note area has been correct to prevent the infinite loop message when more than 250 characters are entered |
| In the Prep selection window, hardware prep information is not editable. Changes to these preps must be made in the Default Prep window |
| Corrected for doubling of hinge jamb preps for cased open frames |
| Corrected error in frame detailing takeoff when duplicating openigns from Bulk Estimate openings |
| Elevation costing now reflects concession discounts for all product and preps |
| Corrected for intermittent error in Project setup, Tasks Tab when entering notes |
| Corrected net pricing for sized hardware products |
| Elevation Costing now shows consistent size of 1’0” instead of 12” |
| The Takeoff Entry window has been corrected for an error when an attribute is entered in lower case |
| The SpecWriter module now has an option to assign a sort sequence for openings in the Hardware, Openings Tab |
| Product Costing now recognizes quoted concessions for new product added |
| Product Costing right click option to add in-house labor has been removed. The recommended method of entering similar costs is by entering a hardware set with a ‘dummy’ opening and a user defined product with a ‘Y’ catalog category |
| Project search window now filters out un-authorized divisions |
| When adding new divisions, the user will now be prompted for a division on which to base the copy. The new division will reflect the same discounts and in-house labor rates as the basis division |
| Corrected for missing frame architect type on various reports |